The AirGun Guild

General Category => Airgun Tanks, Compressors and Filling => Topic started by: steveoh on February 10, 2020, 04:41:11 PM

Title: Yong Heng Filling Tanks
Post by: steveoh on February 10, 2020, 04:41:11 PM
Yong Heng compressor well into its second year of filling tanks.
Title: Re: Yong Heng Filling Tanks
Post by: steveoh on February 10, 2020, 04:49:24 PM
14 mins to fill from 2800 to 4500 psi. This is a 45 minute tank.
Title: Re: Yong Heng Filling Tanks
Post by: Alan on February 10, 2020, 05:03:52 PM
Forty five minutes. That is about the time it takes my Omega to fill my big tank from zero PSI. But then again, it cost about 10 times as much.
Title: Re: Yong Heng Filling Tanks
Post by: Chickenthief on March 10, 2020, 09:43:50 AM
Forty five minutes. That is about the time it takes my Omega to fill my big tank from zero PSI. But then again, it cost about 10 times as much.
No man, 14 minutes ;-)

The tank size is 45min (whatever size that equals to?)
A standard non asmatic firefighter not running or playing poker will gulph up this arbitrary amount of air, so confusing!
In the old world using ISO standards, tanks are measured in liters and rated pressure (which multiplied gives held volume).
Title: Re: Yong Heng Filling Tanks
Post by: steveoh on March 10, 2020, 12:13:19 PM
30 minute cylinder = 45 cu ft.
45 minute cylinder = 66 cu ft.
60 minute cylinder = 88 cu ft

The 45 minute tank is my smaller fireman's 4500 psi tank.