Author Topic: adjusting an Hatsan air stripper  (Read 516 times)

cmsjaffe

  • Newbie
  • *
  • Posts: 19
adjusting an Hatsan air stripper
« on: December 20, 2016, 02:39:09 PM »
Please I am somewhat new to the PCP group I currently own a Hatsan AT 44 s_10 and have purchased an Hatsan air stripper. After reading some of the info on this webb site I am completely confused on the best route to take to adjust the cone . Please would someone help me in layman's language.

Thank you in advanced


  • florida

Alan

  • Administrator
  • Hero Member
  • *****
  • Posts: 2423
  • Set the example... Don't be one!
    • Mobile Amateur Radio
Re: adjusting an Hatsan air stripper
« Reply #1 on: December 21, 2016, 09:53:03 AM »
I'm surprised no one has chimed in about this. I've owned two. I don't know where you bought the stripper, but some are preset specifically for the Hatsan series. They do have a set screw for the center cone, but they're usually cemented in and a bear to loosen.

In any case, don't expect the airgun to be any quieter with the stripper. If you need quiet power, I believe it is possible to upgrade the gun to a QE model.
  • Roswell, New Mexico
Alan

I have an Omega compressor. If you're a fellow Guild member, and you pass through Roswell, NM, I'll fill your portable tank as a courtesy.