Author Topic: Diana springer disassenbly.  (Read 620 times)

EdLena

  • Newbie
  • *
  • Posts: 13
Diana springer disassenbly.
« on: October 23, 2018, 08:33:15 AM »
Has anyone successfully removed the cocking lever hinge pin from the piston cylinder on Diana underlever or possibly breakbarrel rifles?
I thought it was tightly screwed in but when I put enough pressure to it it began to twist without coming out. It may have been pressed in or welded on I don't know.

Ed


  • Tecumseh, Ontario Canada

EdLena

  • Newbie
  • *
  • Posts: 13
Re: Diana springer disassenbly.
« Reply #1 on: October 23, 2018, 10:31:22 AM »
Problem solved, thanks anyway.
  • Tecumseh, Ontario Canada

Alan

  • Administrator
  • Hero Member
  • *****
  • Posts: 2066
  • Set the example... Don't be one!
    • Mobile Amateur Radio
Re: Diana springer disassenbly.
« Reply #2 on: October 23, 2018, 11:47:12 AM »
What did you do?
  • Roswell, New Mexico
Alan

I have an Omega compressor. If you're a fellow Guild member, and you pass through Roswell, NM, I'll fill your portable tank as a courtesy.

EdLena

  • Newbie
  • *
  • Posts: 13
Re: Diana springer disassenbly.
« Reply #3 on: October 23, 2018, 02:22:58 PM »
A friend of mine at the CAF informed me that there is a set screw at the end of the cylinder that holds the hing pin in place. I couldn't see it on the poor on line diagrams.
  • Tecumseh, Ontario Canada

Alan

  • Administrator
  • Hero Member
  • *****
  • Posts: 2066
  • Set the example... Don't be one!
    • Mobile Amateur Radio
Re: Diana springer disassenbly.
« Reply #4 on: October 23, 2018, 05:17:11 PM »
Thank you!
  • Roswell, New Mexico
Alan

I have an Omega compressor. If you're a fellow Guild member, and you pass through Roswell, NM, I'll fill your portable tank as a courtesy.