Author Topic: Raptor Pneumatics (Read 909 times)

Alan · « **on:** June 15, 2017, 02:45:47 PM »

Does anyone have a phone number for Raptor Pneumatics? I have an email address, but no answer. AoA is the dealer, but their service department hasn't returned either of my two calls.

bnowlin · « **Reply #1 on:** June 15, 2017, 03:17:45 PM »

Quote from: Alan on June 15, 2017, 02:45:47 PM

Does anyone have a phone number for Raptor Pneumatics? I have an email address, but no answer. AoA is the dealer, but their service department hasn't returned either of my two calls.

Try Todd Brown 704 252 3024
Bob

Alan · « **Reply #2 on:** June 15, 2017, 04:03:05 PM »

I will give that a try. It is past 7 pm there as I write this, so I'll try in the morning.

bnowlin · « **Reply #3 on:** June 15, 2017, 04:15:45 PM »

Alan he has a speech problem so bear with him. That's his cell but he is in in Arizona.
Bob

Alan · « **Reply #4 on:** June 15, 2017, 04:27:11 PM »

Thank you.

That worked! Thank you over again!

I owe you one Bob!

bnowlin · « **Reply #5 on:** June 15, 2017, 05:18:29 PM »

Alan what' wrong with it.
Bob

Alan · « **Reply #6 on:** June 15, 2017, 05:28:33 PM »

The bleed valve started leaking in two places; the main body, and the screw itself. Although it may have been leaking for some time.

I had two nylon washers, 1/2 inch by 1/32, and two of them with some silicon grease took care of the main body. The seal at the end of the screw was leaking too, and there is a replacement in the parts bag. Todd has them in stock if I need another, but a tad of silicon grease got it to seal back up without replacing it.

The assembly is kind of rare because of the thread size, but he does have the later version. So if it starts leaking again, I'll just replace the whole assembly.

Again, I appreciate the name and number. By the way, AoA finally called me back with the same information on Todd.